• ZaroniPepperoni@lemmy.world
    link
    fedilink
    arrow-up
    16
    ·
    edit-2
    1 year ago

    As a helicopter mechanic, this may not look like a lot, but I can 100% guarantee that the entire helicopter is a write off with that dammage. You would have to rip apart the entire helicopter and put it back together with a bunch of brand new parts for it to be safe again. This at the very least is a total refit requirement. Or some Russian pilots can go die after they did not realize one of those balls embeded itself in the transmission, either works.

  • BombOmOm@lemmy.world
    link
    fedilink
    English
    arrow-up
    7
    ·
    1 year ago

    I’m sure all the electronic boards, tubing for hydraulics, etc just love having little holes punched through them.

    • NotMyOldRedditName@lemmy.world
      link
      fedilink
      arrow-up
      1
      arrow-down
      1
      ·
      1 year ago

      I don’t know if I’m blind, but I’m not seeing too many holes?

      Back during ww1 or ww2 they figured out that the planes that came home with many holes in them, didn’t take catastrophic damage and instead reinforced where there weren’t holes.

      So it’s hard to know if these holes are catastrophic or not

      • partial_accumen@lemmy.world
        link
        fedilink
        arrow-up
        9
        ·
        1 year ago

        I don’t know if I’m blind, but I’m not seeing too many holes?

        Are you looking at the full sized pictures or the shrunk ones? Here’s just one with the holes see circled in red:

        • NotMyOldRedditName@lemmy.world
          link
          fedilink
          arrow-up
          4
          ·
          edit-2
          1 year ago

          Oh damn ya I was looking at the smaller zoomed one. I tried to see if I was doing something wrong even but failed at that. Thanks, much appreciated.

        • Tosti@feddit.nl
          link
          fedilink
          arrow-up
          2
          ·
          11 months ago

          You are cheating by counting each entrance hope at the top and exit hole at the bottom separately… /s

      • Burstar@lemmy.dbzer0.com
        link
        fedilink
        English
        arrow-up
        5
        ·
        1 year ago

        It was WW2. WWI planes did not get armour. They were made typically of wood and canvas and used engines with the same output as a moped. Also, the example you provide is for planes that were hit in mid flight and lived to RTB for examination. This helicopter was hit on the ground and abandoned. Assuming any of the holes aren’t catastrophic would be a dire mistake.

      • CookieOfFortune@lemmy.world
        link
        fedilink
        arrow-up
        3
        ·
        1 year ago

        The survival bias diagram you usually see for this is not necessarily for a single plane but for a number of them and aggregated into the diagram you’re familiar with.

        • towerful@programming.dev
          link
          fedilink
          arrow-up
          1
          ·
          11 months ago

          Also, this was for planes that returned home. IE they could still fly.
          If they were hit like that on the ground, they would probably be written off. Cause it would be an unknown possible death sentence.