I created a 2d surface that I can perform a linear extrusion on, however the result it obviously a hard edge on the extrusion. I would love to be able to add a bezel - either rounded or at 45 degrees. Is there an easy way?

  • azdle@news.idlestate.org
    link
    fedilink
    English
    arrow-up
    0
    arrow-down
    1
    ·
    1 year ago

    There’s lots of ways to round things or chamfer things. Coming from an extruded shape, a basic chamfer is pretty easy, you can do two different extrusions, one a bit shorter than your final piece and one full height, but offset inward a bit, and then hull them together:

    module shape() {
        square(10, center = true);
    }
    
    
    hull() {
        linear_extrude(8)
        shape();
    
        linear_extrude(10)
        offset(delta = -2)
        shape();
    }
    

    Though, because of the hull, this will only really work with fully convex shapes. Doing this for shapes with concave features is harder.

    • azdle@news.idlestate.org
      link
      fedilink
      English
      arrow-up
      0
      arrow-down
      1
      ·
      1 year ago

      For rounding, you can do the extrusion, but with it a bit smaller in every dimension, then minkowski with a sphere (or a different shape if you don’t want all the edges rounded), but it’s tricky to get right:

      module shape() {
          square(80, center = true);
      }
      
      
      minkowski() {
          linear_extrude(80)
          shape();
      
          sphere(r = 20);
      }