In my first ever programming class textbook was using Allman. Probably for this reason, it is easy for a beginner to match braces. It is a lot loss common industry to my knowledge.
If you are working in a decent workplace, you will receive lots of feedback on your code and what you do. Don’t take it personal and learn from them. Sometimes there are multiple correct answers and yours can be one of them, but each workplace, project and senior colleague has their own concerns and priorities. Sometimes feedback seems to be on a trivial mundane detail, and sometimes it really will be. If you think it is valuable feedback, learn. If you disagree, discuss. Enjoy!
As you said before power on capacitor is discharged. Right after power on capacitor is still discharged, so voltage on capacitor is zero, so reset pin has Vcc. With time capacitor gets charges and voltage across capacitor increases and reset voltage becomes closer and closer to ground, until it is ground. But it is important to consider what happens at power down too. At power down capacitor is charged. If power source becomes high impedance at power down, then reset pin will probably go down to zero in time but may take a bit time depending on what source exactly does. But if power source is connected to zero at power down reset pin will observe minus vcc and slowly go up to 0. If reset pin is sensitive it may be a good idea to protect it with a diode.
Immerse yourself into technology. Become the screen.
I don’t know what it is. It just reminded me of ATMEL8051 and I wanted to share.
I used Atmel8051 in college. It fits nicely on a breadboard and teaches you how to use assembly and make wonders with 512 byte (yes byte) RAM if I remember the number correctly. I think half of that RAM was even reserved.
I wish we had an active aoe2 community.
We should stop calling these titles confusing and call them what they are, plain wrong. This is the title of the original article. People who cannot write grammatically correct titles are writing entire articles.
Depending on the power consumption, you may consider not using thermal relief while connecting thermal vias for the chip (component 57) to ground layers. But this may make soldering harder so do it only if needed. Thermal vias are so close that they form 3 long dents in 3v3 plane. It is good practice to put vias a little far apart so that planes can go through between vias. This can be important since sometimes lowest impedance can be obtained when current is flowing between those vias. If you don’t need to fit 15 vias there, you may consider reducing the number and separating them a bit. You can also check the design rules for minimum copper width and minimum via clearance for your manufacturer and enter them in your CAD tool.
I don’t realistically expect such ban to happen. I started banning everyone who posts about Musk instead, my feed got a lot cleaner.
Third siblings who were born right after cameras got affordable have the most pictures.
Not every programmer has a github account.
Web design is not the only option for someone who likes programming. Since you are still a student, there are so many options in front of you. You can be an embedded engineer and work closer to hardware, design firmware, electronic chips themselves or their verification environment. You can be a software engineer and work on business-to-business software which does not include adds and is very useful (e.g. CAD tools, inventory trackers for supermarkets and hospitals etc.). There is so much you can do, pursue something you are enthusiastic about.
vegan or lactose intolerant
But have you tried restarting your computer and reinstalling all drivers?
Trolley problem once climate change hits hard.
Plastic bag or my body?
One-time programmable (memory)