Possible that I’ve posted this here before, but since views seem to be trending upwards and it also might have been on the other instance that’s gone now…
…I positively love these pens, but is there any practical way to disassemble them, or am I stuck with the ink color I chose for them?
Maybe I’m being a dummy, but isn’t that pen a regular cartridge filler? You can just purge it and swap cartridges, no?
Just not quite sure what to do beyond running water through it, that seems to be ineffective at actually cleaning anything below where the cartridge attaches - though I may well be the dummy here, 99% of what I know (which isn’t all that much) is either via experimentation or the internet.
What is your normal routine for flushing the pen when changing inks?
I usually rinse the nib, then remove the converter (I almost never use cartridges). Then I stick the nib into a container of water, and suck water up and push it back out. I have to repeat this dozens of times to get the water to run clear and usually I change the water occasionally while doing this.
For certain pens designed for disassembly with threaded nib units, like my Pelikan M205 or Parker 45, if it is being stubborn or has sat a while I will remove the nib and soak it for a few hours.and also rinse out the rest of the pen. On the 45 it becomes a hollow tube. On the M205 I just put a little water in the reservoir and shake it. Repeat a few times.
Sometimes, if the pen is still not clean after flushing a dozen or two times, I will fill it with water and then leave the pen nib down in a small jar of water (narrow neck, so the pen is mostly upright). Over a few hours the ink reside flows out. And then a final few flushes usually does it.
Can’t really soak hard rubber parts or they discolor, I am told, so I don’t soak those pens.
Occasionally, pen flush (e.g. from Koh-I-Noor) speeds the process a little. And an ultrasonic cleaner can knock the dye residue loose pretty effectively but I rarely use that method anymore.
Hope this helps.
That helps a ton - mostly, I disassemble to the extent possible, rinse individual parts until they run clear, and let dry. The ones that don’t disassemble are the ones that invariably give me trouble.
Upright in a small jar makes perfect sense - the downside to sharing this hobby mostly over the internet is that sometimes I miss obvious stuff like that.
