I started resin printing and I am wondering if you guys use a full on resperator (if so is their a specific classification you’d recommend?) Or do you just use a cloth / surgical mask?

So far I have been using the mask that came with my printer (Elegoo mars 3 pro) but and not sure if that is sufficient.

  • AverageGoob@lemmy.worldOP
    link
    fedilink
    English
    arrow-up
    0
    ·
    1 year ago

    I could open my garage door however I am worried about letting in sunlight and ruining and/or damaging the prints.

    I will take a look for the respirator and cartridges you mentioned!

    • GildedGriffon@discuss.tchncs.de
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      In addition to other suggestions, you could also set up a barrier (cardboard box) that would shade your printer from direct sunlight when the door is open.

      You also don’t need the door open fully. Just open a few inches and turn on a box fan.