I started resin printing and I am wondering if you guys use a full on resperator (if so is their a specific classification you’d recommend?) Or do you just use a cloth / surgical mask?

So far I have been using the mask that came with my printer (Elegoo mars 3 pro) but and not sure if that is sufficient.

  • cat4lyst@lemmy.worldEnglish
    1·
    1 year ago

    If you’re smelling a strong odor then a respirator would be advised. You need one with an organic vapor cartridge. Surgical mask is doing nothing for you in this situation. Probably easier just to get some good ventilation going though. Or minimize you time around the printer.

    • AverageGoob@lemmy.worldOPEnglish
      0·
      1 year ago

      I could open my garage door however I am worried about letting in sunlight and ruining and/or damaging the prints.

      I will take a look for the respirator and cartridges you mentioned!

      • GildedGriffon@discuss.tchncs.deEnglish
        2·
        1 year ago

        In addition to other suggestions, you could also set up a barrier (cardboard box) that would shade your printer from direct sunlight when the door is open.

        You also don’t need the door open fully. Just open a few inches and turn on a box fan.